The Comfort motor control unit with integrated power supply unit transmits move commands from central control units to up to 2 sun shading products with 230 V drives. The installation is either surface-mounted or in-line. The unit generates the 24 V DC control voltage for controlling the motor control unit with a push button or the sun shading control system.

Dual

The motor control unit can control up to two 230 V AC drives of your sun shading products.

Straightforward

The tilt control uses current monitoring to detect motor limit position. This causes automatic upward tilting of slats in the lower limit position.

Direct

The time mode allows for simple, direct control of slat products.

  • Direct control of up to two 230 V sun shading drives via a sun shading control system and a local push button
  • Multiple motor control units can be combined into a group and controlled jointly with one push button.
  • The local formation of groups is performed by diverting the encoding switch.
  • Push button operating mode: Time mode with tilt control mode
  • ZL: In time mode, the MSE enters lock mode after the push button is pressed for approx. 2 seconds. Operating the push button for a shorter duration generates a tilting impulse.
  • Tilt control mode: Slats are automatically tilted up immediately after lower limit position is reached (motor limit position recognised by current monitoring)
  • Tilt angle of the slats can be adjusted
  • Control program for WAREMA external venetian blinds with work setting (snap-action switch and pulse tilting)
  • Integrated power supply unit generates 24 V DC control voltage
Article number: 1002751

Description

Value

Operating voltage

230 V AC

Control voltage

24 V DC

Output

2 x 230 V AC

Switching capacity per drive

500 VA at 230 V AC

Logic behaviour

ZL with tilt

Degree of protection

IP 30

Safety class

I

Type of installation

Surface-mounted (AP)

Width

106 mm

Height

180 mm

Depth

60 mm