EWFS Uniswitch UP is a flush-mounted receiver for directly controlling 230 V sun shading drives via an EWFS transmitter.

Unobtrusive

The receiver is unobtrusively built into a flush-mounted box.

Controlled

Your move command is executed for as long as you operate the transmitter.

Direct

Receives commands from all your EWFS transmitters and sensors and controls your 230 V sun shading drive via the push button inputs of the existing control.

  • Floating contacts
  • For controlling motor control units/switch actuators with their push button inputs via EWFS
  • Dead man operating mode executes move commands as long as the radio transmitter is actuated
  • 24 V DC is supplied via an available central control line, a floor distribution control or a power supply unit
  • Compact design enables installation in a flush-mounted box
Article number: 1002553

Description

Value

Operating voltage

24 V DC

Control voltage

24 V DC

Output

floating

Switching capacity per drive

max. 700 VA at 230 V AC

Transmission frequency

433,92 MHz

Logic behaviour

Dead man

Degree of protection

IP 20

Safety class

II

Type of installation

Flush-mounted (UP)

Width

49 mm

Height

49 mm

Depth

30 mm

Junction box without terminals

Power supply unit for supplying extra low-voltage consumer loads

Power supply unit for supplying extra low-voltage consumer loads

Power supply unit for supplying extra low-voltage consumer loads

Power supply unit for supplying extra low-voltage consumer loads

Device for the operation of motor control units of up to four facades or groups via a higher-level central control unit or for facades on an individual floor via operation on different storeys