The WAREMA climatronic® dim actuator can be used to dim or switch off resistive, inductive and capacitive 230 V AC loads.

Stored

Saves the last setting: the set brightness/dimming level is retained when the system is switched off and set when the system is switched on again.

Protecting

Extends the service life: soft-start and soft-stop at the zero crossing protects the connected power consumer.

Infinitely variable

Well dosed: controls fans from different manufacturers with and without flaps.

  • Controlling up to two power consumers (230 V)
  • Automatic load detection for ohmic, inductive or capacitive loads
  • The set brightness is retained when the system is switched off and set when the system is switched on again
  • Controls and regulates speed of fan drives from different manufacturers
  • Control of fans with supply air flaps is possible
  • Required connecting lines:
    • 230 V connecting line for supplying the connected 230 V power consumers
    • 24 V connecting line from external power supply unit for supplying the actuator
    • 4-wire bus cable (climabus)
  • Connection of conventional push buttons to local individual and group operation (24 V)
  • Allocation of connected sensors when commissioning via control panel or WAREMA climatronic ® studio
  • The operating mode of the connected local push buttons is automatically adjusted to the set product types.
Article number: 1002051

Description

Value

Operating voltage

24 V DC

Output

2 x 230 V AC

Switching capacity per drive

200 VA at 230 V AC

(horizontal installation)

300 VA at 230 V AC

(vertical installation)

Degree of protection

IP 30

Safety class

I

Type of installation

Surface-mounted (AP)

Width

106 mm

Height

180 mm

Depth

60 mm

Power supply unit for supplying extra low-voltage consumer loads

Power supply unit for supplying extra low-voltage consumer loads